Nissan Rogue Owners Manual: Car phone or CB radio

Nissan Rogue Owners Manual / Monitor, climate, audio, phone and voice recognition systems / Car phone or CB radio

When installing a CB, ham radio or car phone in your vehicle, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other electronic parts.

WARNING

A cellular phone should not be used for any purpose while driving so full attention may be given to vehicle operation.
Some jurisdictions prohibit the use of cellular phones while driving.
If you must make a call while your vehicle is in motion, the hands free cellular phone operational mode is highly recommended. Exercise extreme caution at all times so full attention may be given to vehicle operation.
If you are unable to devote full attention to vehicle operation while talking on the phone, pull off the road to a safe location and stop your vehicle.

CAUTION

Keep the antenna as far away as possible from the electronic control modules.
Keep the antenna wire more than 8 in (20 cm) away from the electronic control system harnesses. Do not route the antenna wire next to any harness.
Adjust the antenna standing-wave ratio as recommended by the manufacturer.
Connect the ground wire from the CB radio chassis to the body.
For details, consult a NISSAN dealer.

NissanConnectSM with Mobile Apps (if so equipped)

This vehicle is equipped with Smartphone Integration technology. This allows many compatible Smartphone applications to be displayed and easily controlled through the vehicle’s touchscreen. NO ...

Bluetooth® Hands-Free Phone System without Navigation System (if so equipped)

WARNING Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may ...

Other materials:

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

System
SPORT MODE CONTROL SPORT MODE CONTROL : System Description SYSTEM DIAGRAM SYSTEM DISCRIPTION TCM receives SPORT mode switch signal (ON/OFF) from combination meter via CAN communication. TCM transmit SPORT mode signal to ECM via CAN communication according to the signal. &n ...

Rear power window switch
Removal and Installation REMOVAL Remove screw cover (1). Remove screw (A). Release pawls using a suitable tool (A) and remove rear power window switch finisher (1). : Pawl Disconnect harness connector from rear power window switch. Release the pawls, then sep ...