Description
DTC B1209 - B1211 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a deployment of one or more air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air bag diagnosis sensor unit has not yet been replaced. This DTC can not be erased.
PART LOCATION
Refer to SRC-6, "Component Parts Location".
DTC Logic
DTC DETECTION LOGIC
With CONSULT
CONSULT name |
DTC |
DTC detecting condition |
Repair order |
FRONTAL COLLISION DETECTION | B1421 | Frontal collision detected. Driver and/or front passenger air bag modules are deployed. | Refer to SR-5, "FOR FRONTAL COLLISION : When SRS is activated in a collision" or SR-6, "FOR FRONTAL COLLISION : When SRS is not activated in a collision". |
SIDE COLLISION DETECTION | B1422 | Side collision detected. Curtain air bag module and seat belt pre-tensioner are deployed | Refer to SR-7, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a collision" or SR-8, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a collision" |
DTC CONFIRMATION PROCEDURE (With CONSULT)
1.INSPECTION START
Turn ignition switch ON.
>> GO TO 2.
2.CHECK SELF-DIAG RESULT
Check for the DTC on CONSULT.
Is the DTC detected? YES >> Refer to SRC-97, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
Refer to Frontal collision: SR-5, "FOR FRONTAL COLLISION : When SRS is activated in a collision", SR-6, "FOR FRONTAL COLLISION : When SRS is not activated in a collision" or SR-7, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a collision" or Side and rollover collision: SR-8, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a collision"
Door mirror remote control switch
Removal and Installation
REMOVAL
Release pawls using a suitable tool and remove front door pull handle
(LH). Refer to INT-15, "Exploded
View".
Release pawls (B) using a suitable tool and remove door mirror
remote control switch (1).
Remove screws (A) and d ...
Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the
conditions and environment under
which the malfunction occurred.
>> GO TO 2.
2.CHECK SYMPTOM
...
Starting the engine (models with NISSAN
Intelligent Key® system)
Apply the parking brake.
Move the shift lever to P (Park) or N (Neutral).
P (Park) is recommended.
The starter is designed not to operate if
the shift lever is in any of the driving
positions.
Push the ignition switch to the ON position.
Depress the brake pedal and pus ...